sochaa.blogg.se - Broadcom wl driver monitor mode

View Profile, Aircrack-ng, using airmon-ng to change to … – Ask Ubuntu, Aircrack-ng, using airmon-ng to change to … – Ask Ubuntu, Notice that it says in the bottom (experimental wl monitor mode vif enabled for wlan0 on prism0) for me it says prism0 this is the interface that was created for me when I used the airmon-ng start wlan0 command which is in general called mon0 but it’s not always the same so you need to check the name of the one that was created for you and use it in the next command.

( experimental wl monitor mode vif enabled for wlan0 on prism0) Why does it say experimental wl monitor mode is this an issue because i have been trying to crack a WPA password and had no success even after leaving my command running for 24hrs.

For example: airmon-ng start wlan1 wifite –mon-iface wlan1mon, airmon-ng start wlan0 PHY Interface Driver Chipset phy0 wlan0 wl Broadcom Corporation BCM43142 802.11b/g/n (rev 01) ( experimental wl monitor mode vif enabled for wlan0 on prism0), Enable monitor mode to your adapter and then set the Interface in wifite directly: airmon-ng start MONITOR_INTERFACE wifite –mon-iface MONITOR_INTERFACE.phy0 wlan0 wl Broadcom Corporation BCM4352 802.11ac Wireless Network Adapter (rev 03) ( experimental wl monitor mode vif enabled for wlan0 on prism0) Seems my wl driver is running in monitor mode, or am I wrong (just starting fiddling with Kali 2 days ago, sorry if I’m wrong)….Distributor ID: Ubuntu Description: Ubuntu 18.04.3 LTS Release: 18.04 Codename: bionic My network card in the laptop is, ( experimental wl monitor mode vif already enabled for wlp2s0 on prism0) I have a Samsung Q330 running Ubuntu 18.04.